1-7-17-kolesnye-kolpaki.html
1.7.17. Wheel capsCap removal
Wrap up the montazhka end a fabric, deeply insert it into a groove which is available in a cap of a nave of a wheel, and, operating with a montazhka as the lever, separate a cap from a wheel disk. Insert a montazhka serially into each groove of a cap and pick up it in this way until the cap will not act in film completely.
NOTE
Wheel caps are made of plastic therefore remove them accurately.
|
Cap installation
Combine an opening under the tire gate on a cap A with the gate on a wheel. Then with a hand slightly knock on an external edge (on perimeter) a cap reliably to fix it.
NOTE
On a reverse side of a wheel cap there is the symbolical marking specifying an arrangement of the gate of the tire.
|
Before installation of a wheel cap, provide exact combination of an opening with symbolical marking with the tire gate.
|