Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
1.1. Car description
1.2. Keys, locks of doors and opening elements of a body
1.3. Governing bodies, kontrolnoizmeritelny devices and salon equipment
1.4. Seats
1.5. System of passive safety
1.6. Sitema of heating and conditioning
1.7. Driving and car service
1.7.1. Recommendations about a car running in
1.7.2. Fuel choice
1.7.3. Trailer towage
1.7.4. Ignition lock
1.7.5. Blocking and unblocking of a steering wheel
1.7.6. Engine start-up
1.7.7. Mechanical transmission
1.7.8. A four-high-speed automatic transmission of INVECS-II Sport Mode (with a manual mode of a choice of transfers – an intellectual and innovative control system of the car of the second generation)
1.7.9. Control lamps of AKPP
1.7.10. Positions of the lever of the selector of an automatic transmission (the main cut)
1.7.11. Features of work of an automatic transmission
1.7.12. Parking brake
1.7.13. Adjustment of height of a steering wheel
1.7.14. Tools and jack
1.7.15. Spare wheel
1.7.16. Wheel replacement
1.7.17. Wheel caps
1.7.18. Towage
1.7.19. Engine overheat
1.7.20. Engine start-up from an external source
1.7.21. Fuses
1.7.22. Replacement of lamps
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes

Журналисты сообщили детская одежда hello kitty


1.7.6. Engine start-up

Do not hold a starter included more than 10 with as it can lead to the strong category of the storage battery. If the engine did not start to work, return a key in the ignition lock in the situation "LOCK" ("Blocking"), wait some seconds, and then repeat start-up. Repeated inclusion of a starter to a full stop of the engine can lead to starter breakage.
If the engine is not started because of the partial or full category of the storage battery, act according to instructions on the engine start-up, given in the section «Engine start-up from an external source».
The engine is considered heated-up decreases) enough if the arrow of the index of temperature of cooling liquid starts to move (frequency of rotation of the engine. Too long warming up of the engine will lead to increase in fuel consumption.

At all do not allow operation of the engine in the closed or badly ventilated room more long, than it is necessary for entrance or departure. The oxide of the carbon containing in fulfilled gases, has no smell and can lead to death.

After replacement of the storage battery codes of the electronic control unit will be erased by the engine that can lead to unstable operation of the engine.

Do not try to get the engine by towage or car pushing. It can be very dangerous.
Do not allow operation of the engine with big frequency of rotation or car movement with a high speed while the engine completely did not get warm.

Release the ignition key at once after engine start in order to avoid starter damage.

Engine start-up
This car is equipped with the engine with electronic system of injection of computer-controlled fuel. At start of the engine do not press an accelerator pedal.

Usual (normal) conditions
Procedure of start of the engine the following.
Insert a key into the lock of ignition and fasten a seat belt.
Lift the lever of the parking brake.
Press and hold pressed a brake pedal.
Establish the gear shifting lever in the situation "N" («Neutral transfer»).
Squeeze out up to the end a coupling pedal.
After the key was turned in the ignition lock in the situation "ON" ("Incl.") before starting the engine, check, whether everything control lamps work properly.
Transfer the ignition key to situation to "START’ ("Starter"), without pressing an accelerator pedal, and release a key when the engine will be started.

Clicks which are heard right after engine start-up, arise owing to design features of the engine. It is not a malfunction sign. At further warming up of the engine clicks will disappear. If after engine warming up these noise do not disappear, address to the official dealer of MITSUBISHI for car check.

Reenrichment топливовоздушнои mixes (flood of candles)
If at start-up of the engine there was a reenrichment fuel - an air mix (so-called «a flood of candles»), in the beginning include a starter on 5–6 with at completely pressed pedal of an accelerator then make engine start-up, without pressing an accelerator pedal.

At very low temperature of air
If the engine is not started, at an engine prokruchivaniye a starter squeeze out an accelerator pedal approximately to a half of its course. As soon as the engine will start to work, release an accelerator pedal.

1.7.5. Blocking and unblocking of a steering wheel

1.7.7. Mechanical transmission