Removal and engine installation assembled. Mitsubishi Outlander (since 2003 of release) canada rx connection
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.2.1. Removal
2.2.2. Removal, check and installation of the oil pallet (2WD model)
2.2.3. Removal, check and installation of the oil pallet (4WD model)
2.2.4. Replacement of a belt of a drive of GRM and belt of a drive of the balansirny mechanism (4G64,4G69)
2.2.5. Replacement of a belt of a drive of GRM and belt of a drive of the balansirny mechanism (4G63)
2.2.6. Removal and installation of epiploons of camshafts (4G63)
2.2.7. Removal and installation of forward and back epiploons of a cranked shaft (4G63)
2.2.8. Removal and installation of a head of the block of cylinders (4G64, 4G69)
2.2.9. Removal and installation of a head of the block of cylinders (4G63)
2.2.10. Removal, check and installation of the distributive mechanism
2.2.11. Removal and dismantling of shatunno-piston group
2.2.12. Assembly and installation of shatunno-piston group
2.2.13. Block of cylinders, cranked shaft and flywheel
2.2.14. Block of cylinders
2.2.15. Assembly of components of the block of cylinders
2.3. System of cooling of the engine
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 

2-2-snyatie-i-ustanovka-dvigatelya-v-sbore.html

2.2. Removal and engine installation assembled





NOTE
The engine as a whole can be divided into two parts: skeleton and auxiliary systems. Elements which directly participate in process of development of capacity belong to a skeleton of the engine.

NOTE
The asterisk (*) in drawings noted elements of fastening which are tightened previously and not completely, the final inhaling is made only after the engine is lowered on support.

Technical characteristics



2.1.5. Operations on the heated-up engine
2.2.1. Removal