Check of a leakage of system of cooling. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.3.1. Check of a leakage of system of cooling
2.3.2. Check of pressure of opening of the valve of a stopper of a radiator
2.3.3. Replacement of cooling liquid
2.3.4. Check of the electronic block of the electrofan
2.3.5. Check of the relay of the electrofan
2.3.6. Removal and thermostat installation
2.3.7. Removal and installation of the pump of cooling liquid
2.3.8. Removal and installation of a water hose and water pipe
2.3.9. Removal and installation of a radiator of system of cooling
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







2-3-1-proverka-negermetichnosti-sistemy-okhlazhdeniya.html

2.3.1. Check of a leakage of system of cooling

NOTE
To avoid burns hot cooling liquid, during an opressovka of system of cooling slowly dump superfluous pressure.

ATTENTION
Dry wipe all places of prospective check.
During a detachment of a pneumatic tester be careful not to spill cooling liquid.
At removal and installation of a pneumatic tester, and also during carrying out an opressovka do not damage a jellied branch pipe of a radiator.

Check level of cooling liquid. It should be on level of a jellied mouth of a radiator. Establish a pneumatic tester and create superfluous pressure of 160 kPas. Check leakages of liquid from hoses of a radiator and places of connections.
At existence of leaks repair or replace the corresponding components.


2.3. System of cooling of the engine

2.3.2. Check of pressure of opening of the valve of a stopper of a radiator