Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.3.1. Check of a leakage of system of cooling
2.3.2. Check of pressure of opening of the valve of a stopper of a radiator
2.3.3. Replacement of cooling liquid
2.3.4. Check of the electronic block of the electrofan
2.3.5. Check of the relay of the electrofan
2.3.6. Removal and thermostat installation
2.3.7. Removal and installation of the pump of cooling liquid
2.3.8. Removal and installation of a water hose and water pipe
2.3.9. Removal and installation of a radiator of system of cooling
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







2-3-2-proverka-davleniya-otkrytiya-klapana-probki-radiatora.html

2.3.2. Check of pressure of opening of the valve of a stopper of a radiator

NOTE
Before check clear a radiator stopper. The pollution which have got on sealing laying of a stopper, will lead to the wrong indications.

Check of pressure of opening of the valve of a stopper of a radiator
By means of the adapter connect a pneumatic tester to a stopper.
Increase pressure until while indications of a manometer are not stabilized.
The minimum allowed value: 83 kPas.
Nominal rate: 93–123 kPas.
Replace a radiator stopper in case the received value of pressure does not correspond to the provided data.


2.3.1. Check of a leakage of system of cooling

2.3.3. Replacement of cooling liquid