2-3-6-snyatie-i-ustanovka-termostata.html
2.3.6. Removal and thermostat installation
Sequence of removal
Disconnect the socket of the sensor of temperature of cooling liquid.
Disconnect the socket of the sensor of temperature of cooling liquid.
Disconnect the bottom hose of a radiator.
Remove the socket and an arm of the socket of the sensor of oxygen
Disconnect collars of fastening of plaits of wires.
Remove a branch pipe of a supply of cooling liquid.
Remove the thermostat.
Put sparennost labels on the bottom hose of a radiator and a collar.
Remove the bottom hose of a radiator.
VNIMANI
Be convinced of lack of traces of oil on rubber consolidation of the thermostat. Do not rumple and do not scratch rubber consolidation of the thermostat during installation.
|
Establish the thermostat so that perepuskny the valve was located vertically.
Do not rumple and do not scratch rubber consolidation of the thermostat during installation.
Connection of the bottom hose of a radiator
Put on the bottom hose of a radiator against the stop in a ledge of a bringing branch pipe.
Combine sparennost labels on the bottom hose of a radiator and a collar.
Tighten a collar.
Check of components of the thermostat
Place the thermostat in water.
Heat up capacity, constantly stirring slowly with water.
Register temperature of opening of the main valve of the thermostat.
Nominal rate: 82 ±1,5 °C.
At temperature of complete opening of the valve be convinced that its course is in the established range.
NOTE
For measurement of a full speed of the valve measure valve height when it is in completely closed position.
|
Then measure its height at complete opening and take away value of height at completely closed valve.
Nominal rate: 95 °C.
Valve stroke: 8,5 mm or more.
|