Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.3.1. Check of a leakage of system of cooling
2.3.2. Check of pressure of opening of the valve of a stopper of a radiator
2.3.3. Replacement of cooling liquid
2.3.4. Check of the electronic block of the electrofan
2.3.5. Check of the relay of the electrofan
2.3.6. Removal and thermostat installation
2.3.7. Removal and installation of the pump of cooling liquid
2.3.8. Removal and installation of a water hose and water pipe
2.3.9. Removal and installation of a radiator of system of cooling
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







2-3-8-snyatie-i-ustanovka-vodyanogo-shlanga-i-vodyanojj-truby.html

2.3.8. Removal and installation of a water hose and water pipe

Removal and installation of a water hose and water pipe

The operations which are carried out before removal and after installation of the valve
Merge and fill in cooling liquid.
Remove (establish) the air filter.
Remove (establish) the thermostat.

Sequence of removal of components
Disconnect the top hose of a radiator.
Remove a branch pipe of removal of cooling liquid.
Disconnect a return hose of heating of the case of a butterfly valve.
Disconnect a hose of heating of the case of a butterfly valve.
Remove the thermostat case.
Disconnect a heater hose.
Disconnect a collar of fastening of a plait of wires.
Remove a water pipe.
Remove a rubber sealing ring of a water pipe.

Detachment of the top hose of a radiator
Removal and installation of a water hose and water pipe
Put sparennost labels on the top hose of a radiator and on a collar. After that disconnect the top hose of a radiator.

Installation of a rubber sealing ring of a water pipe

ATTENTION
Do not allow hit of oils on a surface of a rubber sealing ring. Insert a rubber sealing ring into a pro-point on a water pipe. Moisten a surface of a rubber ring with water or cooling liquid.

Installation of the case of the thermostat / a taking-away branch pipe
Removal and installation of a water hose and water pipe
By means of a scraper or a wire brush remove the remains of old hermetic from a sealing joint.
Put on a joint a narrow strip of hermetic.
Hermetic name: original MITSUBISHI hermetic, nomenclature number MD970389 or its equivalent.
In a current of 15 mines after hermetic drawing (hermetic should not be in time полимеризоваться) establish the case of the thermostat or taking-away branch pipe on the engine. Do not put on a joint superfluous amount of hermetic.

Connection of the top hose of a radiator
Removal and installation of a water hose and water pipe
Put on the top hose of a radiator against the stop in a ledge of a taking-away branch pipe.
Combine sparennost labels on the top hose of a radiator and a collar.
Tighten a collar.

Check of a water pipe and hoses of heating of the case of a butterfly valve
After removal check a water pipe and heating hoses on existence of cracks, damages and a contamination.
In case of need replace faulty components.


2.3.7. Removal and installation of the pump of cooling liquid

2.3.9. Removal and installation of a radiator of system of cooling