Removal and installation of a radiator of system of cooling. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.3.1. Check of a leakage of system of cooling
2.3.2. Check of pressure of opening of the valve of a stopper of a radiator
2.3.3. Replacement of cooling liquid
2.3.4. Check of the electronic block of the electrofan
2.3.5. Check of the relay of the electrofan
2.3.6. Removal and thermostat installation
2.3.7. Removal and installation of the pump of cooling liquid
2.3.8. Removal and installation of a water hose and water pipe
2.3.9. Removal and installation of a radiator of system of cooling
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 





вот оно как бывает: http://inspirial.ru.

2-3-9-snyatie-i-ustanovka-radiatora-sistemy-okhlazhdeniya.html

2.3.9. Removal and installation of a radiator of system of cooling

Sequence of removal
Turn out a drain stopper.
Remove a radiator stopper.
Remove a hose of a broad tank.
Remove a broad tank.
Disconnect the top hose of a radiator.
Disconnect the bottom hose of a radiator.
Disconnect the socket of the electronic block of the electrofan.
Disconnect AKP heat exchanger hoses.
Remove the top support of a radiator.
Remove the bottom support of a radiator.
Remove a fan casing with electrofans.
Remove a casing of the fan and the electrofan of the condenser of the conditioner.
Remove a radiator and the fan.
Disconnect the socket of the electronic block of the electrofan.
Remove the fan electric motor.
Remove a fan casing.

Detachment of the top/bottom hose of a radiator
Put sparennost labels on a hose of a radiator and a collar.
Remove radiator hoses.

Connection of the top/bottom hose of a radiator
Put on the bottom hose of a radiator against the stop in a ledge of a bringing branch pipe.
Put on the top hose of a radiator against the stop in a ledge on a taking-away branch pipe.
Combine sparennost labels on hoses of a radiator and on a collar.
Tighten a collar.


2.3.8. Removal and installation of a water hose and water pipe

2.4. Greasing system