Sensor switch check on pressure of engine oil. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.4. Greasing system
2.4.1. Sensor switch check on pressure of engine oil
2.4.2. Removal and installation of a maslookhladitel
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







2-4-1-proverka-datchika-vyklyuchatelya-po-davleniyu-motornogo-masla.html

2.4.1. Sensor switch check on pressure of engine oil

Check level of engine oil.
Disconnect the sensor switch socket on pressure of engine oil.
By means of a special key remove the sensor switch.

ATTENTION
Hermetic is put on carving connection of the sensor switch, be attentive, do not damage the sensor switch at removal.

Connect through an adapter the measuring device (manometer).
Start the engine and leave it to idle (warming up).
After warming up of the engine check compliance of pressure of oil to nominal rate.

Nominal rate
Idling: 29 kPas or are more.
3500 mines-1:.294-686 of kPa
Disconnect the measuring device (manometer).
Put hermetic on a sensor switch carving on pressure of oil before installation.
Hermetic: 3MATD№8660 or its equivalent.

ATTENTION
When drawing hermetic try not to cork the channel of pass of oil.

Establish and tighten the sensor switch the nominal moment of an inhaling.
Inhaling moment: 19 ±3 N · m.

NOTE
After installation of the sensor switch wait not less than an hour before engine start.

Connect the sensor switch socket on pressure of engine oil.


2.4. Greasing system

2.4.2. Removal and installation of a maslookhladitel