Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
2.1. The general procedures of check and prevention without removal of the power unit
2.2. Removal and engine installation assembled
2.3. System of cooling of the engine
2.4. Greasing system
2.5. System of the distributed injection of fuel (MPI) of engines of a series 4G6
2.5.1. General information
2.5.2. Diagnostics of system of injection of fuel
2.5.3. Technical operations on the car
2.5.4. Removal and installation of nozzles
2.5.5. Removal and installation of the case of a butterfly valve
2.5.6. Regulation system топливоподачи
2.5.7. Catching system паров fuels
2.5.8. System of a retsirkulyatsiya of the fulfilled gases (EGR)
2.5.9. Inlet and final systems
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







2-5-6-sistema-regulirovaniya-toplivopodachi.html

2.5.6. Regulation system топливоподачи

NOTE
On the car the pendant pedal and a cable of a drive of a butterfly valve are established.

Specification for adjustments and control
Regulation system топливоподачи

Regulation system топливоподачи

Regulation system топливоподачи

Regulation system топливоподачи

Check and adjustment of a cable of a pedal of an accelerator
Regulation system топливоподачи
Switch off the conditioner, external and internal illumination of the car.
Check and adjustment make in the absence of electric loading.
Warm up the engine before steady work idling.
Check that frequency of rotation cranked a shaft on a mode of idling corresponds to nominal rate.
Muffle the engine.
Check lack of sharp excesses of a cable of a pedal of an accelerator.
Check that the free wheeling of a cable of a pedal of an accelerator (the cable, instead of its braid) is in a range of nominal rates.
If the free wheeling of a cable of an accelerator does not correspond to nominal size adjust it as follows.
Weaken an inhaling of bolts of fastening of an adjusting level of a cable of an accelerator.
Move an adjusting level and adjust size of a free wheeling of a cable of an accelerator, and then tighten bolts of fastening of an adjusting level.
After adjustment check that the lever of a butterfly valve concerns the limiter.

Removal and installation of the sensor of provision of a pedal of an accelerator
Removal of details is made in an order specified in assembly drawing.
Installation is made as it should be, the return to removal.
After installation of details adjust a cable of a pedal of an accelerator.


2.5.5. Removal and installation of the case of a butterfly valve

2.5.7. Catching system паров fuels