Washing of the hydraulic line of the heat exchanger of a transmission. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. The general procedures of check and prevention on the car
3.2. Operations on the heated-up engine
3.2.1. Check of level of liquid in an automatic transmission
3.2.2. Liquid replacement in an automatic transmission
3.2.3. Washing of the hydraulic line of the heat exchanger of a transmission
3.3. Coupling
3.4. Mechanical transmission
3.5. Automatic transmission
3.6. Driveshaft and driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







3-2-3-promyvka-gidravlicheskojj-linii-teploobmennika-korobki-peredach.html

3.2.3. Washing of the hydraulic line of the heat exchanger of a transmission

Disconnect a hose shown in drawing which connects a transmission to the heat exchanger (in a radiator).
Start the engine and let's to working liquid flow down. Position of the selector: at operation of the engine idling, the selector is in the situation "N", idling.

ATTENTION
The engine should be muffled in one minute after its start. If liquid flowed out earlier, respectively and the engine should be muffled earlier.

Amount of merged liquid: about 3,5 l.
Through a tube of supply of oil fill in new liquid.
Recommended quantity: about 3,5 l.

ATTENTION
Stop to fill in liquid at once as will fill in 3,5 l.

Repeat the previous actions.

NOTE
Continue to carry out the operations described earlier until from a tube of cooling, at least, 8,0 l will not merge. After that merge still a small amount of ATF and check on existence of pollution, repeat operations.

Execute the operations specified in a technique of replacement to working liquid.


3.2.2. Liquid replacement in an automatic transmission

3.3. Coupling