3-4-4-snyatie-i-ustanovka-privoda-pereklyucheniya-peredach.html
3.4.4. Removal and installation of a drive of gear shifting
ATTENTION
Do not subject the electronic control unit of system of passive safety to blows during removal and installation of a cable of a choice of transfer and a cable of switching of transfer.
|
Operations before removal and after installation
Remove and establish the block of the air filter.
Remove and establish аккумуляторнуюбатарею and a platform of the storage battery.
Removal of connection of a cable of a choice of transfer (from a transmission) and a clip of draft of gear shifting
Unbend ledges on a clip of draft of gear shifting, using a screw-driver etc., and then remove a clip of draft of gear shifting from an arm together with cables.
Installation of connection of a cable of a choice of transfer (from a transmission) and a clip of draft of gear shifting
Establish the gear shifting lever from a transmission and the gear shifting lever from car salon in neutral situation.
Establish the painted part of the end of a cable of gear shifting (from a transmission) and the painted part of a cable of a choice of transfer (from a transmission) so that they were turned aside шплинта.
NOTE
Accurately establish a clip of draft of switching of transfer, a cable of a drive of switching and a cable of a choice of transfer to a zashchelkivaniye.
|
After installation of a new clip of draft of gear shifting on a cable arm on a transmission, establish a cable of a drive of switching and a cable of a choice of transfer to a cable arm.
Moving the gear shifting lever to all provisions, check that it moves smoothly.
Installation of a clip of a cable of gear shifting
Make sure that in a clip of a cable of gear shifting on the end of a cable of gear shifting there is no excessive gap. If the excessive gap takes place or the clip of a cable of gear shifting was disconnected from the end of a cable of gear shifting, check a gap in a clip. If a gap – more than 9.5 mm, compress a clip of a cable of gear shifting, before formation of a gap of 5-8 mm in a free condition.
Block of the lever of gear shifting
Insert a clip of a cable of gear shifting into a hook on a cable of gear shifting and press a clip of a cable of gear shifting by thumbs before click.
Establish a cable of a drive of switching on the gear shifting lever.
|