Removal and installation of the lever of the selector assembled. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. The general procedures of check and prevention on the car
3.2. Operations on the heated-up engine
3.3. Coupling
3.4. Mechanical transmission
3.5. Automatic transmission
3.5.1. Precautionary measures necessary at dismantling and assembly of AKP
3.5.2. Hermetic use as laying
3.5.3. Checks of components of management of AKP
3.5.4. Removal and installation of the lever of the selector assembled
3.6. Driveshaft and driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







3-5-4-snyatie-i-ustanovka-rychaga-selektora-v-sbore.html

3.5.4. Removal and installation of the lever of the selector assembled

The operations which are carried out before removal and after installation.
Removal and installation of a lateral cover and bottom cover.
Removal and installation of a ware box of the floor console.
Check of operation of the lever of the selector (only after installation).

ATTENTION
Be careful, do not subject the electronic control unit of additional system of passive safety of SRS to any blows during removal and installation of a cable of the selector and the selector lever assembled.

Check of chains of the sensor switch of switching assembled

Check of mechanisms of blocking of switching of AKP modes

The main operations at installation (nut installation)
Establish the AKP selector lever in the situation "N".
Weaken an adjusting nut; accurately pull a cable of the lever of the AKP selector in the direction specified in drawing, and tighten a nut.

Check of the sensor of complete opening of a butterfly valve


3.5.3. Checks of components of management of AKP

3.6. Driveshaft and driving mechanism