Removal and driveshaft (4WD) installation. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. The general procedures of check and prevention on the car
3.2. Operations on the heated-up engine
3.3. Coupling
3.4. Mechanical transmission
3.5. Automatic transmission
3.6. Driveshaft and driving mechanism
3.6.1. Removal and driveshaft (4WD) installation
3.6.2. Driveshaft check
3.6.3. Dismantling and driveshaft assembly
3.6.4. Removal and installation of a shaft of a drive of a wheel assembled
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 





adwokat odszkodowania warszawa, kom

3-6-1-snyatie-i-ustanovka-kardannogo-vala-4wd.html

3.6.1. Removal and driveshaft (4WD) installation


Removal
Put labels of relative provision of a flange of the driveshaft and a flange of a leading gear wheel of differential.
Remove the driveshaft.

ATTENTION
Remove the driveshaft in the direct direction and the horizontal plane so that not to allow damage of a protective cover about edge of a metal part of a cover.

NOTE
Damage of a protective cover can be prevented and performance of operation of removal will be simplified if to insert a piece of a fabric or a similar material into narrowing of a protective cover.

Installation
Installation is made as it should be, the return to removal.
At installation of details pay attention to operation on driveshaft installation assembled.

ATTENTION
Be careful, do not damage a working edge of an epiploon of a transfer case at driveshaft installation.

Before an inhaling of nuts and bolts carefully clear a carving of fixing details of oil or greasing for prevention of weakening of fastening of the driveshaft at operation.
Establish the driveshaft in the direct direction and the horizontal plane so that not to allow damage of a protective cover about edge of a metal part of a cover.
If the driveshaft which was in operation (removed earlier) is established, combine labels of relative provision of a flange of the driveshaft and a flange of a leading gear wheel of differential.
If the new driveshaft assembled is established, combine a label on a driveshaft pipe with a label on боковине a flange of a leading gear wheel of differential.


3.6. Driveshaft and driving mechanism

3.6.2. Driveshaft check