Removal and installation of a nave of a forward wheel assembled. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. The general procedures of check and prevention on the car
4.2. Tires and wheels
4.3. Peredny Bridge
4.3.1. General information
4.3.2. Removal and installation of a nave of a forward wheel assembled
4.3.3. Dismantling and assembly of a nave of a forward wheel assembled
4.4. Forward suspension bracket
4.5. Back suspension bracket
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







4-3-2-snyatie-i-ustanovka-stupicy-perednego-kolesa-v-sbore.html

4.3.2. Removal and installation of a nave of a forward wheel assembled



ATTENTION
During removal and installation of a power shaft be careful not to strike a gear wreath of the sensor of speed of rotation of a wheel which is established on an external ring of the external hinge of equal angular speeds. Otherwise the gear wreath of the sensor will be damaged.
During works on maintenance be careful not to strike the polar tip located in the top part of the sensor of speed of rotation of a forward wheel.

The operations which are carried out after installation
Check a condition of a protective cover, having paid attention to cracks and other damages. For this purpose press a cover fingers.

Support removal assembled
Fix the dismantled support assembled by means of a wire or a similar subject,

Removal of a brake disk
If the brake disk does not act in film, screw bolts М8х1,25, as is shown in drawing. Remove a brake disk, evenly and alternately tightening bolts.


4.3.1. General information

4.3.3. Dismantling and assembly of a nave of a forward wheel assembled