Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. The general procedures of check and prevention on the car
4.2. Tires and wheels
4.3. Peredny Bridge
4.4. Forward suspension bracket
4.5. Back suspension bracket
4.5.1. General information
4.5.2. Removal and installation of levers of a suspension bracket
4.5.3. Installation of the top lever in the collecting / managing director of a bar of a suspension bracket
4.5.4. Removal and installation of the longitudinal lever assembled
4.5.5. Removal and shock-absorber installation assembled
4.5.6. Dismantling and assembly of an amortizatorny rack
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







4-5-2-snyatie-i-ustanovka-rychagov-podveski.html

4.5.2. Removal and installation of levers of a suspension bracket

Removal of the managing director of a bar / bottom lever of a suspension bracket assembled
Removal and installation of levers of a suspension bracket
Having put an adjusting label on an adjusting bolt of a convergence or disorder, disconnect an operating bar or the bottom lever assembled.

Detachment of the top lever in collecting / the bottom lever in collecting and the longitudinal lever
Removal and installation of levers of a suspension bracket
Having propped up the bottom lever a jack, disconnect the top lever in collecting / the bottom lever in collecting and the longitudinal lever of a suspension bracket.

Connection of a rack of the stabilizer
Removal and installation of levers of a suspension bracket
Tighten самоконтрящуюся a nut so that the length of an acting carving part of a rack of the stabilizer of cross-section stability left on nominal size.
Nominal rate And: 6–8 mm


4.5.1. General information

4.5.3. Installation of the top lever in the collecting / managing director of a bar of a suspension bracket