4-5-4-snyatie-i-ustanovka-prodolnogo-rychaga-v-sbore.html
4.5.4. Removal and installation of the longitudinal lever assembled
Point of support (when lifting car / suspension bracket)
Detachment of the bottom lever in collecting and the longitudinal lever of a suspension bracket
At removal of the longitudinal lever, displace a little forward (to a forward part of the car) a lift paw that it did not disturb lever removal.
Having propped up the bottom lever a jack, disconnect the bottom lever assembled from the longitudinal lever of a suspension bracket.
Installation of a rack of the stabilizer
Tighten самоконтрящуюся a nut so that the length of an acting carving part of a rack of the stabilizer of cross-section stability left on nominal size.
Nominal rate (And): 6–8 mm.
Check
Check a condition of plugs on wear or destruction existence.
Check a condition of the longitudinal lever on existence of curvature or damages.
Replacement of the plug of the longitudinal lever
Choose the directions of installation of the plug and its situation at a press fitting in the longitudinal lever of a suspension bracket.
Establish an internal tube of the long end of the plug to an internal part of the car.
Be convinced, that the cavity of the plug of the longitudinal lever settled down how is shown in drawing.
By means of the special tool, press the plug of the longitudinal lever how it is shown in drawing.
For a vypressovka of the plug of the longitudinal lever of a suspension bracket use the following special tool.
– МВ990890: basis of the plug of a back suspension bracket.
– МВ990947: an opravka for the plug of the bottom lever of a suspension bracket.
– МВ991816: the basis for removal / installation of plugs.
|