Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. The general procedures of check and prevention on the car
4.2. Tires and wheels
4.3. Peredny Bridge
4.4. Forward suspension bracket
4.5. Back suspension bracket
4.5.1. General information
4.5.2. Removal and installation of levers of a suspension bracket
4.5.3. Installation of the top lever in the collecting / managing director of a bar of a suspension bracket
4.5.4. Removal and installation of the longitudinal lever assembled
4.5.5. Removal and shock-absorber installation assembled
4.5.6. Dismantling and assembly of an amortizatorny rack
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







4-5-5-snyatie-i-ustanovka-amortizatora-v-sbore.html

4.5.5. Removal and shock-absorber installation assembled

Removal and shock-absorber installation assembled

Otvorachivaniye of a bolt of the bottom lever of a suspension bracket
Removal and shock-absorber installation assembled
Having propped up the bottom lever a jack, unscrew a bolt of the bottom lever.

Shock-absorber installation assembled
Removal and shock-absorber installation assembled
Establish a step part of the bottom cup of a spring of the shock-absorber so that it was turned to a back part of the car.

Installation of a rack of the stabilizer
Removal and shock-absorber installation assembled
Tighten самоконтрящуюся a nut so that the length of an acting carving part of a rack of the stabilizer of cross-section stability left on nominal size.
Nominal rate (And): 6–8 mm.

Check
Check a condition of rubber details on existence of cracks or wear tracks.
Check a shock-absorber condition on working capacity violation, existence of leaks or emergence of knocks.


4.5.4. Removal and installation of the longitudinal lever assembled

4.5.6. Dismantling and assembly of an amortizatorny rack