Removal and installation of a steering wheel. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. A steering with the hydraulic booster
5.2. The general procedures of check and prevention on the car
5.2.1. Check of a free wheeling and check of an angle of rotation of a steering wheel
5.2.2. Check of the moment of the beginning of a provorachivaniye of the spherical hinge of a tip of steering draft
5.2.3. Check of effort of turn of a steering wheel at the motionless car
5.2.4. Check of self-return of a steering wheel in the provision of rectilinear movement
5.2.5. Check of level of working liquid in system
5.2.6. Replacement of working liquid in system
5.2.7. Air removal from system
5.2.8. Test of the hydropump of system for developed pressure
5.2.9. Check of the sensor switch of pressure of the hydraulic booster of a steering
5.2.10. Check of a protective cover of the spherical hinge of a tip of steering draft
5.2.11. Check of the power absorbing mechanism of a steering column assembled
5.2.12. Removal and installation of a steering wheel
5.2.13. Removal and installation of a shaft of a steering column
5.2.14. Removal and installation of the hydropump of the amplifier of a steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







5-2-12-snyatie-i-ustanovka-rulevogo-kolesa.html

5.2.12. Removal and installation of a steering wheel


ATTENTION
At removal and installations of a steering wheel, do not allow blows about the module of an inflatable safety cushion.

Additional operations after installation.
Check coincidence of provision of a steering wheel to the provision of rectilinear movement of forward wheels.

Cover removal
Insert a stripper of ornaments (МВ990784), as is shown in drawing and uncover.

NOTE
This tool can be inserted into dredging from the back party of the specified place.

Removal of a steering wheel and module of an inflatable safety cushion assembled
Move section A of the socket of an hour spring in the arrow direction, as is shown in drawing, disconnect the socket.
Completely turn out a bolt. Then remove a steering wheel and the module of an inflatable safety cushion assembled.

NOTE
For performance of this operation it is necessary to use a six-sided head or a six-sided key in length not less than 75 mm of a six-sided part of a key and diameter not less than 8 mm.


5.2.11. Check of the power absorbing mechanism of a steering column assembled

5.2.13. Removal and installation of a shaft of a steering column