Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. A steering with the hydraulic booster
5.2. The general procedures of check and prevention on the car
5.2.1. Check of a free wheeling and check of an angle of rotation of a steering wheel
5.2.2. Check of the moment of the beginning of a provorachivaniye of the spherical hinge of a tip of steering draft
5.2.3. Check of effort of turn of a steering wheel at the motionless car
5.2.4. Check of self-return of a steering wheel in the provision of rectilinear movement
5.2.5. Check of level of working liquid in system
5.2.6. Replacement of working liquid in system
5.2.7. Air removal from system
5.2.8. Test of the hydropump of system for developed pressure
5.2.9. Check of the sensor switch of pressure of the hydraulic booster of a steering
5.2.10. Check of a protective cover of the spherical hinge of a tip of steering draft
5.2.11. Check of the power absorbing mechanism of a steering column assembled
5.2.12. Removal and installation of a steering wheel
5.2.13. Removal and installation of a shaft of a steering column
5.2.14. Removal and installation of the hydropump of the amplifier of a steering
6. Brake system
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







5-2-13-snyatie-i-ustanovka-vala-rulevojj-kolonki.html

5.2.13. Removal and installation of a shaft of a steering column

Removal and installation of a shaft of a steering column

Removal of a shaft of a steering column assembled

ATTENTION
The control lever should be kept by an inclination of a steering column in the locked situation before the completion of installation of a steering column. If the steering column acts in film with the released lever of an inclination, or the lever of an inclination was released after removal of a shaft of a steering column, shaft installation the helmsman of a column cannot be correctly executed. If the steering column is established incorrectly, the power absorbing mechanism can be damaged.

Removal and installation of a shaft of a steering column
Be convinced of that the inclination lever the helmsman of a column is in the locked situation then unscrew assembly bolts of a steering column.
Compress пассатижами a clamp of a shaft of a steering column and pull out a shaft in the direction of an arrow to disconnect a shaft of a steering column assembled.

Installation of a shaft of a steering column assembled

ATTENTION
At a reuse of a steering column, do not release a control lever an inclination till the completion of installation to the place of a shaft of a steering column.


5.2.12. Removal and installation of a steering wheel

5.2.14. Removal and installation of the hydropump of the amplifier of a steering