5-2-14-snyatie-i-ustanovka-gidronasosa-usilitelya-rulevogo-upravleniya.html
5.2.14. Removal and installation of the hydropump of the amplifier of a steeringHydropump removal assembled
Raise the engine a jack, then turn out an assembly bolt (from the bottom party) the hydropump from a pulley.
Check
Check a condition of a belt of a drive on existence of cracking.
Check a pulley condition on existence of non-uniform wear.
Installation of ring laying
Epiploon installation
For installation of an epiploon it is recommended to use the special tool.
– МВ990938: (deposit) core.
– МВ991203: the adaptation for installation of epiploons and bearings.
Installation of a statorny ring of the hydropump
ATTENTION
Be convinced of the correct installation of a statorny ring of the hydropump, as is shown in drawing.
|
Establish a statorny ring how it is shown in drawing.
Check
Check a condition of the valve of management of an expense on contamination existence.
Check a condition of a pulley and its shaft on existence of wear or damages.
Check a condition of a rotor and flutes of blades on existence of "step" wear.
Check a condition of a statorny ring and blades on existence of "step" wear.
Check a condition of blades on existence of damages.
Installation of a returnable hose
Establish a returnable hose that its labels were located how it is shown in drawing.
Installation of a soaking-up hose
Establish a returnable hose (from the hydropump) that its labels were focused forward.
|