Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. The general procedures of check and prevention on the car
6.2.1. Check of level of working liquid in a hydraulic actuator of brakes
6.2.2. Check of free and working courses of the lever of the parking brake
6.2.3. Check люфта in bearings of forward naves
6.2.4. Stock-taking of leaks in tubes and hoses of brake system
6.2.5. Check of a brake disk
6.2.6. Check and adjustment of a pedal of a brake
6.2.7. Check of operation of the return valve
6.2.8. Check of work of a regulator of pressure of back brakes
6.2.9. Check of the sensor of level of brake liquid
6.3. Parking brake
6.4. Anti-blocking system of brakes (ABS – 2WD)
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







6-2-8-proverka-raboty-regulyatora-davleniya-zadnikh-tormozov.html

6.2.8. Check of work of a regulator of pressure of back brakes

Check of work of a regulator of pressure of back brakes
Connect two manometers respectively to an entrance and an exit of a regulator of pressure as is shown in drawing.
Remove air from hydrosystem of brakes and manometers.
Smoothly pressing a brake pedal, make the following measurements, and be convinced that results are in admission limits.
Check of work of a regulator of pressure of back brakes
Pressure on an exit starts to fall concerning pressure on an entrance (an inclusion point).
Nominal size: 2,7–3,19 MPas
Check and be convinced that at increase in effort of pressing at a brake pedal, pressure of liquid on an exit is in the set limits, thus pressure on an entrance corresponds to the values given in the table.
Nominal size: 3,68–4,17 MPas.
Difference of pressure on an exit between right and left hydrosystem contours.
The most admissible value: 0,39 MPas.
If results of measurements of pressure do not correspond nominal, replace a pressure regulator.


6.2.7. Check of operation of the return valve

6.2.9. Check of the sensor of level of brake liquid