Extra earnings of brake slips. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. The general procedures of check and prevention on the car
6.3. Parking brake
6.3.1. Extra earnings of brake slips
6.3.2. Removal and installation of the lever of the parking brake
6.3.3. Removal and installation of brake slips and drum-type mechanism
6.3.4. Removal and installation of the main brake cylinder and vacuum amplifier of brakes
6.3.5. Removal and installation of disk brakes
6.3.6. Dismantling and assembly of a disk brake
6.3.7. Dismantling and assembly of a back drum-type brake
6.4. Anti-blocking system of brakes (ABS – 2WD)
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







6-3-1-prirabotka-tormoznykh-nakladok.html

6.3.1. Extra earnings of brake slips

ATTENTION
Execute operations after extra earnings of brake slips in a place with good visibility, pay special attention to providing to security measures. Execute the following operations for extra earnings of brake slips at replacement of brake shoes of back wheels or at replacement of brake disks of back wheels or in case of unsatisfactory operation of brake system.

Rotation of an adjusting nut adjust a working course of a drive of the parking brake on nominal level.
Recommended value: 5–7 teeth (the effort enclosed to the lever of a drive of the parking brake: makes about 200 N).
Fasten to an average part of the handle of the parking brake a spring dynamometer and pull for it effort of 100-150 N in the direction perpendicular to the handle.
Pass on the car distance about 100 ms in the constant speed of 35-50 km/h.
Release the lever of the parking brake and let's to the brake mechanism cool down within 5–10 minutes.
Repeat this operation at stages with 2 on 4 four-five times to be convinced of normal work of brake system.

Check of the switch of a control lamp of the parking brake
Remove the back console assembled.
Remove a forward seat assembled (on the right side).
Check conductivity existence between a conclusion of the switch of a lamp of the parking brake and an assembly bolt of the switch.
At the extended lever of the parking brake: no more than 2 Ohm;
At the released lever of the parking brake: rupture of a chain.


6.3. Parking brake

6.3.2. Removal and installation of the lever of the parking brake