Removal and installation of the main brake cylinder and vacuum amplifier of brakes. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. The general procedures of check and prevention on the car
6.3. Parking brake
6.3.1. Extra earnings of brake slips
6.3.2. Removal and installation of the lever of the parking brake
6.3.3. Removal and installation of brake slips and drum-type mechanism
6.3.4. Removal and installation of the main brake cylinder and vacuum amplifier of brakes
6.3.5. Removal and installation of disk brakes
6.3.6. Dismantling and assembly of a disk brake
6.3.7. Dismantling and assembly of a back drum-type brake
6.4. Anti-blocking system of brakes (ABS – 2WD)
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







6-3-4-snyatie-i-ustanovka-glavnogo-tormoznogo-cilindra-i-vakuumnogo-usilitelya-tormozov.html

6.3.4. Removal and installation of the main brake cylinder and vacuum amplifier of brakes


Installation of connection of a vacuum hose
Insert a hose against the stop while the hose from the engine will not concern edge of a six-sided part of the union, and then fix it a collar.

Check and adjustment of length of an acting part of a rod of a pusher
The measured size A.
Nominal size: 9,65–9,90 mm
If the length of an acting part of a rod of a pusher does not correspond to nominal rate, adjust it, rotating a tip of a rod of a pusher.


6.3.3. Removal and installation of brake slips and drum-type mechanism

6.3.5. Removal and installation of disk brakes