Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. The general procedures of check and prevention on the car
6.3. Parking brake
6.3.1. Extra earnings of brake slips
6.3.2. Removal and installation of the lever of the parking brake
6.3.3. Removal and installation of brake slips and drum-type mechanism
6.3.4. Removal and installation of the main brake cylinder and vacuum amplifier of brakes
6.3.5. Removal and installation of disk brakes
6.3.6. Dismantling and assembly of a disk brake
6.3.7. Dismantling and assembly of a back drum-type brake
6.4. Anti-blocking system of brakes (ABS – 2WD)
7. Onboard electric equipment
8. Body
9. Appendix
10. Electric equipment schemes
 







6-3-7-razborka-i-sborka-zadnego-barabannogo-tormoza.html

6.3.7. Dismantling and assembly of a back drum-type brake

Assembly of the piston and sealing ring of the piston
Dismantling and assembly of a back drum-type brake
Before assembly wash out the piston and the cylinder alcohol or applied brake liquid.
Grease with brake liquid a sealing ring of the piston and the special tool.
Applied brake liquid: D0T3 or D0T4.
Put on a sealing ring of the piston a special opravka so that the sharp edge was turned upward and then, lowering on an opravka down, establish it in a piston flute.

ATTENTION
To avoid twisting or a distortion of a sealing ring of the piston at installation, lower it slowly and accurately, one movement without stops.


6.3.6. Dismantling and assembly of a disk brake

6.4. Anti-blocking system of brakes (ABS – 2WD)