7-4-8-snyatie-i-ustanovka-datchika-detonacii.html
7.4.8. Removal and installation of the sensor of a detonation
Sequence of removal
Disconnect the socket of the sensor of pressure of the amplifier of a steering.
Disconnect the socket of the compressor of the conditioner.
Remove a clamp of the socket of the compressor of the conditioner.
Remove the pump of the amplifier of a steering.
Remove an arm of the pump of the amplifier of a steering.
Remove the central cover.
Disconnect the socket of the sensor of provision of a cranked shaft.
Remove the sensor of provision of a cranked shaft.
Remove an arm of fastening of the socket of the sensor.
Removal of the pump of the hydraulic booster of a steering
Remove from an adjusting arm the pump of the hydraulic booster of a steering with the connected hoses.
ATTENTION
Take away the pump so that it did not disturb further work. In this situation fix it a strong rope or a wire.
|
ATTENTION
Do not allow blows or falling of the removed sensor of a detonation. In this case there can be its damage of the sensor of a detonation and, probably, sensor replacement is required.
|
Disconnect the socket of the sensor of a detonation 1.
Remove the sensor of a detonation 2.
For removal of the sensor of a detonation use a special key (MD998773).
Installation of the sensor of a detonation
For installation of the sensor of a detonation use a special key (MD998773). Tighten the sensor the demanded moment of an inhaling.
|