Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. Power supply system
7.3. Electrostart-up system
7.4. Ignition system
7.5. Lighting system
7.6. Heater, conditioner and ventilation system
7.6.1. Technical operations on the car
7.6.2. Coolant addition in system by means of a charging cylinder
7.6.3. Filling with oil of system of the conditioner
7.6.4. Technique of elimination of a leak of a coolant
7.6.5. Check of the power relay
7.6.6. Check of work of system in a mode of warming up of the engine
8. Body
9. Appendix
10. Electric equipment schemes
 







7-6-2-dobavlenie-khladagenta-v-sistemu-pri-pomoshhi-zaryadnogo-balona.html

7.6.2. Coolant addition in system by means of a charging cylinder

Coolant addition in system by means of a charging cylinder
Establish the charging valve with the handle against the stop delayed back (the valve is open) on a charging cylinder.
Establish the valve adapter with the handle against the stop delayed back (the valve is closed) on the charging valve.
Connect a charging hose (dark blue color) to the valve adapter.
Connect a charging hose (dark blue color) to the quick-detachable socket (low pressure).
Tighten the handle of the charging valve (the valve is closed) to pierce a charging cylinder.
Turn the valve adapter handle to remove air.
Coolant addition in system by means of a charging cylinder
Connect quick-detachable connection (for low pressure) to the service valve of low pressure.

ATTENTION
The service valve of low pressure should be connected to a bringing hose.

Start the engine.
Turn on the conditioner, establish a mode of the minimum temperature (MAX. COOL).
Keep frequency of rotation of a cranked shaft of the engine at level of 1500 mines-1.
Tighten the valve adapter handle (the valve is open), fill system with a coolant, supervising its level through viewing glass.
Upon termination of system filling with a coolant, turn the valve adapter handle against the stop back (the valve is closed) and disconnect the quick-detachable socket.

ATTENTION
If in a charging cylinder there was a coolant, keep it before the following filling, having densely closed the valve adapter.

Oporozhneniye system
For an oporozhneniye of system it is recommended to apply special installation to regeneration of system of the conditioner.

ATTENTION
Address to equipment operating instructions for regeneration of central air of air.


7.6.1. Technical operations on the car

7.6.3. Filling with oil of system of the conditioner