Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged and decorative elements of a body
8.2.1. Removal and installation of a front bumper
8.2.2. Dismantling and assembly of a front bumper
8.2.3. Removal and installation of a rear bumper
8.2.4. Removal and front grille installation
8.2.5. Removal and installation of overlays of wings
8.2.6. Removal and installation of moldings
8.2.7. Removal and installation of a molding of a threshold
8.2.8. Removal and installation of a protective film of a frame of glass of a lateral door
8.2.9. Removal and installation of a back spoiler
8.2.10. Removal and installation of support of a luggage carrier of a roof
8.2.11. Cowl adjustment
8.2.12. Adjustment of the hatch of a jellied mouth of a fuel tank
8.2.13. Adjustment of forward and back lateral doors
8.2.14. Adjustment of glass of a lateral door
8.2.15. Check of a course of the external handle of a lateral door
8.2.16. Current check in a chain of the electric drive of a window regulator
8.2.17. Removal and cowl installation
8.2.18. Removal and installation of a lateral door assembled
8.2.19. Removal and installation of the lock and handle of a lateral door
8.2.20. Removal and installation of a back door assembled
8.2.21. Removal and installation of the lock and handle of a back door
8.2.22. Removal and installation of the hatch of a roof
8.2.23. Removal and installation of a lateral rear-view mirror
9. Appendix
10. Electric equipment schemes
 







8-2-16-proverka-sily-toka-v-cepi-ehlektroprivoda-steklopodemnika.html

8.2.16. Current check in a chain of the electric drive of a window regulator

Current check in a chain of the electric drive of a window regulator
Remove a safety lock of a chain of the electric drive of a window regulator and connect a tester, as is shown in drawing.
At transfer of the switch of a window regulator to the situation "UP" the maximum current appears in time between the beginning of lifting of glass and its extreme situation (glass is completely lifted). Therefore measurement of a current should be carried out in a range between these two provisions.
Nominal rate: 5 ±1 And (at temperature of 23 °C and tension 14,5 ±0,3 In).
If the current does not correspond to nominal rate, malfunction of the electric drive of a window regulator, malfunction of the switch of a window regulator, defect of the socket or a plait of wires can be the reason.


8.2.15. Check of a course of the external handle of a lateral door

8.2.17. Removal and cowl installation