Removal and installation of a rear bumper. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged and decorative elements of a body
8.2.1. Removal and installation of a front bumper
8.2.2. Dismantling and assembly of a front bumper
8.2.3. Removal and installation of a rear bumper
8.2.4. Removal and front grille installation
8.2.5. Removal and installation of overlays of wings
8.2.6. Removal and installation of moldings
8.2.7. Removal and installation of a molding of a threshold
8.2.8. Removal and installation of a protective film of a frame of glass of a lateral door
8.2.9. Removal and installation of a back spoiler
8.2.10. Removal and installation of support of a luggage carrier of a roof
8.2.11. Cowl adjustment
8.2.12. Adjustment of the hatch of a jellied mouth of a fuel tank
8.2.13. Adjustment of forward and back lateral doors
8.2.14. Adjustment of glass of a lateral door
8.2.15. Check of a course of the external handle of a lateral door
8.2.16. Current check in a chain of the electric drive of a window regulator
8.2.17. Removal and cowl installation
8.2.18. Removal and installation of a lateral door assembled
8.2.19. Removal and installation of the lock and handle of a lateral door
8.2.20. Removal and installation of a back door assembled
8.2.21. Removal and installation of the lock and handle of a back door
8.2.22. Removal and installation of the hatch of a roof
8.2.23. Removal and installation of a lateral rear-view mirror
9. Appendix
10. Electric equipment schemes
 







8-2-3-snyatie-i-ustanovka-zadnego-bampera.html

8.2.3. Removal and installation of a rear bumper


Removal
Remove the back combined lamp.
Remove an overlay of a threshold of a back door.
Uncover a ventilating opening.
Disconnect the socket of a plait of wires of a rear bumper.
Removal of details is made in an order specified in drawing.

Removal of clamps
By means of flat-nose pliers compress latches of holders and then remove holders from salon.
Installation of details is made as it should be, the return to removal.
After completion of installation of details connect the socket of a plait of wires of a rear bumper.
Establish a cover of a ventilating opening.
Establish an overlay of a threshold of a back door.
Establish the back combined lamp.


8.2.2. Dismantling and assembly of a front bumper

8.2.4. Removal and front grille installation