Removal and installation of a molding of a threshold. Mitsubishi Outlander (since 2003 of release)
Repair and Mitsubishi Outlander service since 2003 of release.
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged and decorative elements of a body
8.2.1. Removal and installation of a front bumper
8.2.2. Dismantling and assembly of a front bumper
8.2.3. Removal and installation of a rear bumper
8.2.4. Removal and front grille installation
8.2.5. Removal and installation of overlays of wings
8.2.6. Removal and installation of moldings
8.2.7. Removal and installation of a molding of a threshold
8.2.8. Removal and installation of a protective film of a frame of glass of a lateral door
8.2.9. Removal and installation of a back spoiler
8.2.10. Removal and installation of support of a luggage carrier of a roof
8.2.11. Cowl adjustment
8.2.12. Adjustment of the hatch of a jellied mouth of a fuel tank
8.2.13. Adjustment of forward and back lateral doors
8.2.14. Adjustment of glass of a lateral door
8.2.15. Check of a course of the external handle of a lateral door
8.2.16. Current check in a chain of the electric drive of a window regulator
8.2.17. Removal and cowl installation
8.2.18. Removal and installation of a lateral door assembled
8.2.19. Removal and installation of the lock and handle of a lateral door
8.2.20. Removal and installation of a back door assembled
8.2.21. Removal and installation of the lock and handle of a back door
8.2.22. Removal and installation of the hatch of a roof
8.2.23. Removal and installation of a lateral rear-view mirror
9. Appendix
10. Electric equipment schemes
 







8-2-7-snyatie-i-ustanovka-moldinga-poroga.html

8.2.7. Removal and installation of a molding of a threshold

Removal of details is made in an order specified in drawing.
At removal of details pay attention to operation of removal of an overlay of a threshold.
Installation of details is made as it should be, the return to removal.

Installation of a protective film

ATTENTION
Be convinced that ambient temperature is in limits of 20-38 °C and a surface in a place of fastening of a protective film. the pure.

Еспи ambient temperature less than 20 °C, heat up a protective film and a surface of its installation till 20-30 «Page.
At installation of a protective film be convinced that under a film air vials were not formed.
Clear (degrease) isopropyl alcohol of an installation site of a protective film.
Remove a paper substrate and paste a protective film, as is shown in drawing.


8.2.6. Removal and installation of moldings

8.2.8. Removal and installation of a protective film of a frame of glass of a lateral door